The AR 33 Softwash Skid with a Honda engine is an awesome cleaning machine!
Pump: AR33 Manufactured by Annovi Reverberi, AR North America
- Max Pressure: 290 PSI
- Max GPM: 8
Engine: Honda Pull Start
Helpful Info:
Inlet Size: 1 1/4"
Bypass Size: 3/4"
Outlet Size: 1/2"
If using a proportioner, we recommend using the HydroMixer XL
Shipping Info: This item will ship on a pallet with a freight truck. Our system will automatically calculate a shipping price based upon a commercial address with a forklift or loading dock available. This is our preferred shipping method. We do offer residential service with a liftgate. If the address you provide is calculated as residential we will email you a quote for the additional services needed. If you feel like the shipping rates are too high, please give us a call. Our website only allows us to have one freight carrier. We may have other options available. 770-532-4442
*Shipments to California are not available through our website at this time. CA customers must contact us directly to check machine's compliance before shipping quotes will be provided.
For the motor, please refer to the Honda manual warranty information. The AR pumps do have a warranty. However, the warranty is voided once used with harsh chemicals such as sodium hypochlorite. We do recommend that customers test their systems completely with water upon initial set-up. Please contact us immediately if you have any issues at all. We are happy to assist our customers with troubleshooting.
To increase the longevity of your softwash skid, we have provided a list of recommendations:
*Relieve the pressure from the pump when starting and stopping the engine. You can do this by pulling the trigger on your softwash gun or switching the system into bypass mode- directions for this are on the AR pump manual.
*Thoroughly rinse the pump out after each use.
*Keep your pressure below 250 PSI. You can adjust the pressure on the regulator.
*Minimize the amount of time that the pump stays in bypass mode. This becomes more important when using with a proportioner (blend manifold). Keeping a minimum 25' of bypass line will help when using a proportioner set up.
*Protect your pump from freezing
